STI7711 Silicone Direct Print Black Dye Blocker is a silicone-rubber ink to be printed as an underbase with any direct print silicone ink colour to resist dye migration on 100% polyester dark fabrics, sub-dyed fabrics, or any 100% polyester fabric known to cause dye migration. Multiple coatings of direct emulsion, capillary films or a print/flash/print technique during printing may be needed to achieve desired effect. STI7711 will not cure without being catalyzed.

TECHNICAL INFORMATION

Ideal Fabric— 100% Polyester Performance wear fabrics.

Mesh–83-125/inch (32T-48Tcm) High Density Inks – 83-125/inch (43T-48Tcm)

Squegee–70 durometer or 70/90/70 Triple Durometer.

Stencil–Any PVC-free or phthalate-free emulsion compatible with plastisol inks.

Curing–250-290F (125-147C) for 1.5 to 2 minutes.

Additives–Viscosity Reducer 3-4% by weight maximum

Storage–30C/84F in tightly closed containers

Cleaning–Enviro Series TR Blend or Mineral Spirits

 

CAUTION
Always test finished prints for curing, adhesion, opacity, bleed-resistance and desired look prior to beginning full production runs. Lancer Group International cannot guarantee the results or back claims that this ink will test PVC-free or phthalate-free if any additive other than an additive manufactured by Lancer Group International is used to modify this ink. Test results by a third-party laboratory verifying all components used to produce this ink are PVC-free, phthalate-free and lead-free are available upon request.