AquaPro Retroflec Silver and White are direct-print, water-based reflective inks that
produce reflective prints that are more durable and more reflective than most plastisol
versions. Garments printed with Retroflec will provide higher visibility in low-light
situations for joggers, cyclists or construction workers who wear the garment in low-light
situations. Prints made with Retroflec are not recognized by insurance companies as
their reflectivity does not meet safety standards for reduced rates. This is a two-part ink
system, please pay attention to the mixing instructions below.


Ideal Fabric: Cotton/Poly Cotton Blends or 100% Polyester.

Mesh: 83-305/inch (32-120cm)

Squegee: 70 durometer or 70/90/70 Triple Durometer.

Stencil: Water-proof stencils only.

Curing: Heat cure at 300°-330° F (150°-165° C) for 90 seconds or longer.

Pigment Loading: N/A

Additive: 5-30% by weight AquaLife Retarder.
5% AquaFix Additives for small dryers.

Storage: 60°-90° F (30°-45°C) with lids closed.

Cleaning: Warm water immediately after printing and use Enviro Series 2000 Green for difficult spots.

Always test finished prints for curing, adhesion, opacity and desired look prior to beginning full production run. Lancer Group International cannot guarantee the results or back claims that this ink will test PVC-free, phthalate-free or formaldehyde-free if any additive other than an additive recommended and manufactured by Lancer Group International is used to modify this ink.