Lancer Group’s STI7835 Silicone Direct Print High Density Series contains a thick silicone rubber mixing base and RFU White and Black for producing 3D high-density decorations on performance fabrics. STI7835 Mixing Base creates custom colours when used in conjunction with Evolution Pigment Concentrates. Finished prints made with STI7835 will have a thick ink film with sharp edges and a flat surface. When printing on dark colours, sub-dyed fabrics or fabrics known to migrate, it may be necessary to underbased colours with STI7581 White and back with STI7711 Defender Black Dye Blocker. Depending upon height of the finished decoration, a print/flash/print technique, building up layers of the ink may be necessary. Multiple coatings of direct emulsion or capillary films that produce thicker stencils will make it easier to achieve the desired height. Note: This ink must be catalyzed prior to printing.

TECHNICAL INFORMATION

Ideal Fabric— 100% Polyester Performance wear fabrics.

Mesh–83-125/inch (32T-48Tcm) High Density Inks – 83-125/inch (43T-48Tcm)

Squegee–70 durometer or 70/90/70 Triple Durometer.

Stencil–Any PVC-free or phthalate-free emulsion compatible with plastisol inks.

Curing–250-290F (125-147C) for 1.5 to 2 minutes.

Additives–Viscosity Reducer 3-4% by weight maximum.

Storage–30C/84F in tightly closed containers

Cleaning–Enviro Series TR Blend or Mineral Spirits

CAUTION
Always test finished prints for curing, adhesion, opacity, bleed-resistance and desired look prior to beginning full production runs. Lancer Group International cannot guarantee the results or back claims that this ink will test PVC-free or phthalate-free if any additive other than an additive manufactured by Lancer Group International is used to modify this ink. Test results by a third-party laboratory verifying all components used to produce this ink are PVC-free, phthalate-free and lead-free are available upon request.