The AquaPrint Series is an improved, next generation Waterbased textile ink. Stencils used to print AquaPrint will stay open far longer than previous versions. AquaPrint not only produces brilliant, soft-feeling prints on dark garments that will stretch and retract easily but, also have excellent adhesion to a wide variety of substrates such as spandex, leather, lycra, cotton/poly blends and porous nylons. Prints made with AquaPrint are fully washable and can be dry cleaned. In low-humidity environments an addition of 5-30% by weight of AquaLife Retarder will greatly extend stay-open time. When using a short dryer where a dwell time of 90 seconds cannot be reached or, if air drying, an addition of 2-5% AquaFix Additive will allow the ink to fully cure after 72 hours.

TECHNICAL INFORMATION

Ideal Fabric: 100% Cotton Fabrics.

Mesh: 83-305/inch (32-120cm)

Squegee: 70 durometer or 70/90/70 Triple Durometer.

Stencil: Water-proof stencils only.

Curing: 320°F (160° C) for 90 seconds.

Pigment Loading: N/A

Additive: 5-30% by weight AquaLife Retarder.
5% AquaFix Additives for small dryers.

Storage: 60°-90° F (30°-45°C) with lids closed.

Cleaning: Warm water immediately after printing and use Enviro Series 2000 Green for difficult spots.

CAUTION
Always test finished prints for curing, adhesion, opacity and desired look prior to beginning full production run. Lancer Group International cannot guarantee the results or back claims that this ink will test PVC-free, phthalate-free or formaldehyde-free if any additive other than an additive recommended and manufactured by Lancer Group International is used to modify this ink.